Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 102)

LabMaster 9 Zi-A
94 922157-00 Rev A
Turning on Channels and Traces
Turn on a channel, math, or memory trace using the Front Panel channel
buttons, or the menu bar.
The dialog at the bottom of the screen automatically switches to the
vertical setup or math setup dialog for that selection.The tab on this dialog
is labeled with the corresponding channel number:
You can configure your traces from here, including math setups.
PLEASE NOTE THE FOLLOWING:

If you want to display each trace on its own grid automatically, enable
Autogrid by touching Display → Autogrid from the menu bar.

You can turn channels on and off using the software, for more
information see Vertical Overview (on page 111)

On the front panel, press a channel select button to display the trace
descriptor label for that input channel and turn on the channel.
NOTE: On a LabMaster 9 Zi-A, you can also turn channels on and off from
the front of the 9xxSZi-A Slave Acquisition Module or from the front of
the 9xxMZi-A Master Acquisition Module, where applicable.

Turn on a math function trace by touching Math → Math Setup... from
the menu bar. Touch the corresponding On checkbox to activate the
desired trace.

You can also quickly create traces (and turn on the trace label) for math
functions and memory traces, without leaving the Vertical Adjust dialog,
by touching the icons at the bottom of the Vertical Adjust dialog.