Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 77)

Getting Started Manual
922157-00 Rev A 69
designed for connection to a 2.92 mm Probe Connection Interface to be
connected to a ProLink input connection. For instance, this could be used
to connect a 25 GHz probing system using 2.92 mm and LEMO connections
for connection to a ProLink input.
Connecting the ProLink Probe Adapter is done in a similar way as
connecting a ProLink Interface Adapter.
Probe Dialog
Teledyne LeCroy proprietary probe interfaces provide a complete
measurement solution from probe tip to oscilloscope display. The Probe
Dialog displays probe attenuation and other information, and allows you to
make tip select and other probe settings from the oscilloscope
touchscreen.
The following figure shows a typical channel dialog on a Teledyne LeCroy
oscilloscope containing both ProLink (Input A, Upper) and ProBus (Input B,
Lower) interfaces. The input selection is on the left-hand side of the dialog
box.
When the probe is not connected, there is only a C1 tab selection for
vertical channel setup and the user has the ability to select input coupling
and probe attenuation.
Channel dialog showing Input A's interface controls setup before connection.