Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 243)

Getting Started Manual
922157-00 Rev A 235
Safety Compliance
EC D
ECLARATION
O
F
C
ONFORMITY
–
L
OW
V
OLTAGE
The oscilloscope meets intent of EC Directive 2006/95/EC for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:

Measurement Category II: equipment intended to be supplied
from the building wiring with a nominal supply voltage up to 300V.

Measurement Category 0: oscilloscope measurement terminals
that are not intended to be directly connected to the MAINS
supply.

Pollution Degree 2: an operating environment where normally only
dry, non-conductive pollution occurs. Occasionally a temporary
conductivity that is caused by condensation must be expected.
This location is a typical office/home environment.

Protection Class I: grounded equipment in which protection against
electric shock is achieved by Basic Insulation and a connection to
the protective ground conductor in the building wiring.
U.S. N
ATIONALLY
R
ECOGNIZED
A
GENCY
C
ERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark:
UL 61010-1 Second Edition – Safety standard for electrical measuring and
test equipment.