Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 168)

LabMaster 9 Zi-A
160 922157-00 Rev A
Measurement Parameters
Parameters are measurement tools that determine a wide range of
waveform properties. Use them to automatically calculate many attributes
of your waveform, like rise-time, rms voltage, and peak-to-peak voltage, for
example.
There are parameter modes for the amplitude and time domains, custom
parameter groups, and parameters for pass and fail testing. You can make
common measurements on one or more waveforms.
Turning On Parameters
1. Touch Measure → Measure Setup... on the menu bar.
2. Touch the On checkbox for each parameter you want to enable.
3. Touch the Show Table checkbox to display the parameters below
the grid.
Quick Access to Parameter Setup Dialogs
You can quickly gain access to a parameter setup dialog by touching the
parameter listbox in the table below the grid.
For example, touch within P1 to display the P1 setup dialog.
Touch the Measure column on the table display to show the main Measure
dialog.