Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 152)

LabMaster 9 Zi-A
144 922157-00 Rev A
PLEASE NOTE THE FOLLOWING:

You can tune the dwell time that the oscilloscope waits before loading the
next trigger setup using the Dwell Time data entry control.

If you have Persistence display mode enabled, all trigger events are
recorded on the display. Refer to the Persistence Setup (on page 149)
topic for instructions on enabling Persistence display mode.

If you want TriggerScan to stop when the next oscilloscope trigger, check
the Stop On Trigger checkbox. You can use this to isolate specific trigger
setups.
Saving TriggerScan Setups
You should save TriggerScan setups once you have made any modifications
to the Trigger List. The current Trigger List is not be preserved after exiting
the application unless you save it.
1. On the TriggerScan dialog, touch inside the Setup File Name data
entry control and providing a file name using your preferred input
control method. Additional information on using the touch screen
controls can be found in the Dialog Area (on page 87).
OR
Touch the Browse button and select a location and file name.
2. Touch the Save Setup... button.
NOTE: You can load previously saved TriggerScan setups by touching the Browse
button, locating the file, and then touching Load Setup....