Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 196)

LabMaster 9 Zi-A
188 922157-00 Rev A
Mask Testing
Users may load or create a pixel-based mask on the display grid using a
variety of methods. Test conditions can be set, and a pass/fail result
returned based on whether the condition was found to be true or false.
The source of the mask is always a trace (Channel, Zoom, Math waveform).
Creating a Mask
1. After selecting Analysis → Pass/Fail, the Pass/Fail dialog is shown.

If you touch the Q1 button, a pop-up is shown where you can
select the Mask test Pass Fail Condition.
Now, the Q1 dialog shows the Mask test condition selected.

If you touch the Q1 tab, the Q1 dialog is shown. Touch Condition
and select the Mask test Pass Fail Condition from the pop-up.