GW Instek AFG-2000 User Manual - Manual (Page 101)

REMOTE INTERFACE
99
<offset> -5V ~ +5V (50Ω)
*AFG-2005/2105 limited to 5MHz, AFG-2012/2112
limited to 12MHz.
Example SOURce1:APPL:SQU MAX, DEF, DEF
Outputs a 100mVpp (DEF) square wave at 25MHz
with 0 offset (DEF).
SOURce[1]:APPLy:RAMP
Set
Description Outputs a ramp wave when the command has
executed. Frequency, amplitude and offset can also
be set. The symmetry is fixed to 100%.
Syntax SOURce[1]:APPLy:RAMP [<frequency> [,<amplitude>
[,<offset>] ]]
Parameter <frequency> 0.1Hz~1MHz
< amplitude > 1mV~10V (50Ω)
<offset> -5V ~ +5V (50Ω)
Example SOUR1:APPL:RAMP 2KHZ,MAX,MAX
Sets the frequency to 2kHz and sets the amplitude
and offset to the maximum.
SOURce[1]:APPLy:NOISe
Set
Description Outputs Gaussian noise with a 20 MHz
bandwidth. Amplitude and offset can also be set.
Note
The Frequency parameter is not used with the
noise function; however a value (or DEFault) must
still be specified. The frequency is remembered for
the next function used.
Syntax SOURce[1]:APPLy:NOISe [<frequency|DEFault>
[,<amplitude> [,<offset>] ]]
Parameter <frequency> 0.1Hz~25MHz*
<amplitude> 1mV~10V (50Ω)