GW Instek AFG-2000 User Manual - Manual (Page 69)

OPERATION
67
Frequency Sweep
(AFG-2100 Series)
The function generator can perform a sweep for sine, square or ramp
waveforms, but not noise, and ARB. In Sweep mode, the function
generator will sweep from a start frequency to a stop frequency over
a number of designated steps. If an external source is selected, the
function generator can be used to output a single sweep each time a
TTL level pulse is received from the Trigger input port. The step
spacing of the sweep can be linear or logarithmic. The function
generator can also sweep up or sweep down in frequency. The
Sweep function only applies to the AFG-2105, AFG-2112 and the
AFG-2125.
Sweep
Selecting Sweep
Panel Operation 1. Press the Sweep key.
Sweep
2. The modulation, sweep and counter menu
display will appear. The Sweep icon indicates
that the Sweep function is active.