Sweep mode, Sweep rate – GW Instek AFG-2000 User Manual User Manual
Page 72
AFG-2000 Series User Manual
70
Sweep Mode
Sweep mode is used to select between linear or logarithmic
sweeping. Linear sweeping is the default setting.
Panel Operation
1. Press the Shift + LIN/LOG
key to select linear (LINS)
or logarithmic (LOGS)
sweeps.
Shift
+
LIN/LOG
%
→
2. The LINS or LOGS icon will be displayed at
the bottom of the screen.
Example:
Sweep = LINS
Sweep Rate
The sweep rate is used to determine how long it takes to perform a
sweep from the start to stop frequencies. The function generator
automatically determines the number of discrete frequencies used in
the scan depending on the length of the scan.
Panel Operation
1. Press the Shift + Rate key.
Shift
+
Rate
FSK
2. The Rate icon will flash in the frequency
display area.