GW Instek AFG-2000 User Manual - Manual (Page 111)

REMOTE INTERFACE
109
SOURce[1]:VOLTage:UNIT
Set
Query
Description Sets or queries the output amplitude units. There
are three types of units: VPP, VRMS and DBM. The
SOURce[1]:VOLTage:UNIT command does not set
the offset units.
Note
The units set with the VOLTage:UNIT command
will be used as the default unit for all amplitude
units unless a different unit is specifically used for
a command, such as those used with the Apply
commands.
Syntax SOURce[1]:VOLTage:UNIT {VPP|VRMS|DBM}
Example SOUR1:VOLT:UNIT VPP
Sets the amplitude units to Vpp.
Query Syntax SOURce[1]:VOLTage:UNIT?
Return Parameter VPP Vpp
VRMS Vrms
DBM dBm
Query Example SOUR1:VOLT:UNIT?
>VPP
The amplitude units are set to Vpp.