HT instruments FULLTEST3 - Manual (Page 65)

FULLTEST 3
EN - 64
6.5.2. LIMIT CONTACT VOLTAGE menu
This menu shall be used in order to select limit contact voltage which is used in RCD and in R A
measurements. The voltage may be either 25 or 50 V.
50 V 25 V
CONTACT VOL.
Figure 57 : CONTACT VOL. menu
Select wished limit contact voltage by pressing appropriate touch-screen key, the menu will turn to
SETUP menu.
6.5.3. DATE/TIME menu
In order to set date and time DATE/TIME menu shall be used.
Figure 58 : DATE/TIME menu
Enter actual date and time by using the , and 0 ... 9 keys. Confirm it by pressing the ENTER
touch-screen key. Time starts to run on this confirmation.
6.5.4. RESET menu
There are many adjustable parameters in the FULLTEST 3 tester. If an operator due to any reason
wishes to reset all adjustable parameters to factory-set values, the operation can be done by using the
RESET menu.
Confirm RESET operation by pressing the YES touch-screen key or press the EXIT hard key to exit the
menu. Turn the tester off and on again by using the ON/OFF mains switch.