HT instruments FULLTEST3 - Manual (Page 77)

FULLTEST 3
EN - 76
10. ENTRY OF DATA BY USING AN EXTERNAL KEYBOARD
The optional USB keyboard is a welcome accessory when inserting memory address construction
(customer, machine and location) as well as comment, in order to do the job quickly and simply.
Connect the USB keyboard to USB2 or USB3 connector, three sound signals will follow after plugging it,
as a confirmation of USB-device recognition. Now, the external keyboard is operational.
11. ENTRY OF DATA USING A BARCODE READER
The optional USB barcode reader is a welcome accessory when inserting memory address structure
(customer, machine and location) as well as comment, in order to do the job quickly and simply.
Connect the USB barcode reader to USB2 or USB3 connector, three sound signals follow after plugging
it, as a confirmation of USB device recognition.
12. FW UPDATE OF THE FULLTEST 3
The FW update can be done through USB drive, follow the next steps:
- Download new FW version for example B03.M04.V02 from PC to USB drive.
- Connect the USB drive to USB2 or USB3 connector of the FULLTEST 3, label DO YOU WISH TO
UPDATE TO VERSION B03.M04.V02? will appear.
- Confirm upload operation by pressing the YES touch-screen key.
- Wait until the display returns to initial screen then remove the USB drive, new FW is thus installed.
13. MAINTENANCE
When using the instrument in compliance with the instruction manual, no special maintenance is
required. However, should functional errors occur during normal operation, our after sales service will
repair your instrument without delay.
13.1. CLEANING
If the tester is needed to be cleaned after daily usage, it is advisable to use a wet cloth and a mild
household detergent.
Prior to cleaning, remove the machinery tester from all measurement circuits and from mains.
Never use acid-based detergents or dissolvent liquids for cleaning.
After cleaning it, do not use the instrument until it is completely dried up.
13.2. FUSE REPLACEMENT
If, due to overload or improper operation, a fuse blows, it is necessary to obey the following notes for
replacement:
WARNING
Prior to replacement of blown fuse, the Machinery-Tester FULLTEST 3 must be disconnected from all
measuring circuits and mains supply cord must be removed from mains supply socket.
• Use only fuses specified and rated in technical specifications.
• Use of unspecified fuses and in particular shortcircuiting fuse-holders is prohibited.
• Spare fuses can be obtained in electric supplies wholesale shops or in our factory service.