In-Situ Aqua TROLL 400 Modbus and SDI-12 Reference Guide - Manual (Page 26)

2.5.2 SDI-12 Setup
SDI-12 setup allows you to set the instrument address, select the parameters you intend to log,
and select the order in which the parameters will appear in the log.
Screen Element Purpose
Address character
(text field)
Allows you to assign a unique SDI-12 address to the instrument. Use 0-9, A-Z, or
a-z.
Reload From Device
(button)
Restores the settings that were last written to the instrument.
Write to Device
(button)
Writes the parameters and the address to the instrument.
Select Parameters
(button)
Allows you to enable and disable parameters. Click the Select Parameters button
and click the checkboxes to select or clear parameters.
Parameter Up
(button)
Allows you to move a parameter higher in the list. Click the parameter and then
click the Parameter Up button until the desired location is reached.
Parameter Down
(button)
Allows you to move a parameter lower in the list. Click the parameter and then
click the Parameter Down button until the desired location is reached.
26