Allied Telesis AT-S63 - Manual (Page 108)

Chapter 8: File System
108 Section II: Advanced Operations
 Be sure to include the “.cfg” extension.
 Precede the name with “cflash:” if the file is stored on a flash card
in the switch.
5. Click Apply.
The switch searches the file system or flash memory card for the file. If
it finds the file, it displays the file name in the Default Configuration File
field along with the word “Exists.” The file is now the active boot
configuration file on the switch.
If the switch can not locate the file, it displays the name of the previous
boot configuration file. Repeat steps 4 and 5, being sure to enter the
name correctly.
6. Do one of the following:
 To configure the switch using the parameter settings in this boot
configuration file, do not select Save Config. Instead, reset or
power cycle the switch.
 To overwrite the settings in the configuration file with the switch’s
current operating settings, select Save Config.