Allied Telesis AT-S63 - Manual (Page 332)

Chapter 21: GARP VLAN Registration Protocol
332 Section V: Virtual LANs
Configuring GVRP
To configure GVRP, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 132.
Figure 132. GVRP Tab (Configuration)
4. In the GVRP Parameters section, configure the following parameters
as necessary.
Note
The settings for the three timers must be the same on all GVRP-
active network devices.
Enable GVRP
Click to enable or disable GVRP.