Allied Telesis AT-S63 - Manual (Page 214)

Chapter 17: SNMPv3
214 Section III: SNMPv3
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
 “Creating a View Table Entry” on page 214
 “Deleting a View Table Entry” on page 217
 “Modifying a View Table Entry” on page 217
For reference information about the SNMPv3 View Table, see Chapter 21,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure at the bottom of the tab.