Configuring mstp, Configuring mstp parameters – Allied Telesis AT-S63 User Manual
Page 294
Chapter 19: Multiple Spanning Tree Protocol
294
Section IV: Spanning Tree Protocols
Configuring MSTP
This section contains the following procedures:
“Configuring MSTP Parameters,” next
“Configuring the CIST Priority” on page 297
“Configuring MSTP Port Parameters” on page 302
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to “Enabling MSTP” on page 292.
Note
When MSTP is enabled, the GVRP tab is not shown on the
Configuration or Monitoring Layer 2 page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 109 on page 272.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 121.