Allied Telesis AT-S63 - Manual (Page 370)

Chapter 23: 802.1x Port-based Network Access Control
370 Section VI: Port Security
Update Interval
Specifies the intervals at which the switch sends interim accounting
updates to the RADIUS server. The range is 30 to 300 seconds. The
default is 60 seconds.
5. Click Apply.
Changes to the accounting settings are immediately implemented on
the switch.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Displaying the
RADIUS
Accounting
Settings
To display the RADIUS accounting settings, perform the following
procedure:
1. From the home page, select Monitoring.
2. From the Monitoring menu, select the Network Security option.
3. Select the 802.1x Port Access tab. The 802.1x Port Access tab is
shown in Figure 148 on page 365.
The RADIUS Accounting section provides the following information:
Accounting
The status of RADIUS accounting, either Enabled or Disabled.
Trigger Type
The action that causes the switch to send accounting information to
the RADIUS server. The possible settings are:
Start_Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
Stop - The switch sends accounting information only when a client logs
off.
Port Number
The UDP port for RADIUS accounting.
Type
The type of RADIUS accounting. The default is Network.
Accounting Update
Whether or not the switch sends interim accounting updates to the
RADIUS server. The options are Enabled or Disabled.
Update Interval
The intervals, in seconds, at which the switch sends interim
accounting updates to the RADIUS server.