Allied Telesis AT-S63 - Manual (Page 293)

AT-S63 Management Software Web Browser User’s Guide
Section IV: Spanning Tree Protocols 293
4. To change the active spanning tree protocol on the switch, click STP,
RSTP, or MSTP in the Active Protocol Version section of the tab. The
default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
5. To enable or disable the active spanning tree protocol on the switch,
click the Enable Spanning Tree check box. A check indicates that the
spanning tree is enabled while no check indicates that spanning tree is
disabled. The default is disabled.
6. Click Apply.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.
8. If you activated STP, go to “Configuring STP” on page 274. If you
activated RSTP go to “Configuring RSTP” on page 282. If you
activated MSTP, go to “Configuring MSTP” on page 294.