Allied Telesis AT-S63 - Manual (Page 299)

AT-S63 Management Software Web Browser User’s Guide
Section IV: Spanning Tree Protocols 299
7. In the Priority field, enter an MSTI Priority value. This parameter is
used in selecting a regional root for the MSTI. The range is 0 (zero) to
61,440 in increments of 4,096, with 0 being the highest priority. This
parameter is used in selecting a regional root for the MSTI. For a list of
the increments, refer to Table 5, “Bridge Priority Value Increments” on
page 276. The default is 0.
8. To add VLANs to the MSTI, enter the VIDs in the VLAN List field.
Separate multiple VIDs with a comma.
9. Click Apply.
The management software creates the MSTI.
10. Repeat steps 5 to 9 to create additional MSTIs.
11. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying an
MSTI
To modify an MSTI, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 109 on page 272.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 121 on
page 295.
5. In the CIST/MSTI Table section of the tab, click the button next to the
MSTI ID to be modified. You can only modify one MSTI ID at a time.
You cannot modify CIST.
6. Click Modify.