Allied Telesis AT-S63 - Manual (Page 181)

AT-S63 Management Software Web Browser User’s Guide
Section II: Advanced Operations 181
No Does not copy the traffic to a destination mirror port. This is the
default.
Traffic Class List
Specifies the traffic class to be assigned to the policy. The traffic class
must already exist. A policy can have more than one traffic class. To
select more than one traffic class, hold down the Ctrl key when making
your selections.
Ingress Port List
Specifies the ingress port to which the policy is to be assigned. A policy
can be assigned to more than one ingress port. To select more than
one port, hold down the Ctrl key when you make your selections. A
port can be an ingress port of only one policy at a time.
Egress Port
Specifies the egress port to which the policy is to be assigned. You can
enter only one egress port.
A port can be an egress port of only one policy at a time. If a port is
already an egress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
Redirect Port
Specifies a port to where the traffic is to be redirected. Traffic that
matches the defined traffic flow is redirected to the specified port. You
can specify only one port.
6. When you are finished configuring the parameters, click Apply.
If the new policy was assigned ports, it is now active on the designated
ports.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying a
Policy
To modify a policy, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Services option.
3. Select the Policies tab.
The Policies tab is shown in Figure 64 on page 178.
4. Select the policy to be modified from the list and click Modify.