Allied Telesis AT-S63 - Manual (Page 98)

Chapter 7: Port Mirroring
98 Section I: Basic Features
Disabling a Port Mirror
This procedure disables a port mirror. When disabled, a port mirror stops
copying traffic from the source ports to the destination port. However, the
destination port is still reserved for port mirroring. To delete the port mirror
so that the destination port can be used for normal network operations,
refer to “Deleting a Port Mirror” on page 99.
To disable a port mirror, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Mirroring tab.
The Port Mirroring tab is shown in Figure 26 on page 94.
4. Click Modify.
The Modify Mirror page is shown in Figure 27 on page 95.
5. Click the Enable Mirror checkbox to remove the check and disable
the mirror.
6. Click Apply.
The port mirror is now disabled. The switch stops copying the traffic on
the source ports to the destination port.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.