Allied Telesis AT-S63 - Manual (Page 241)

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 241
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Address Table. After making changes to a Target Address Table
entry with a NonVolatile storage type, the Save Config option is
displayed on the Configuration menu. Allied Telesis recommends this
storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Target Address
Table entry takes effect immediately.
13. Click Apply to update the SNMPv3 Target Address Table.
14. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting a Target
Address Table
Entry
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Address Table tab is shown in Figure 91 on page
239.
4. Click Next or Previous to display the SNMPv3 Target Address Table
entry to be deleted.
5. Click Remove.
A warning message is displayed.
6. Click OK.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.