Allied Telesis AT-S63 - Manual (Page 227)

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 227
Configuring the SNMPv3 SecurityToGroup Table
You can create, delete, and modify an SNMPv3 SecurityToGroup Table
entry. See the following procedures:
 “Creating a SecurityToGroup Table Entry” on page 227
 “Deleting a SecurityToGroup Table Entry” on page 230
 “Modifying a SecurityToGroup Table Entry” on page 230
For reference information about the SNMPv3 SecuritytoGroup Table, see
Chapter 21, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure
SecurityToGroup Table and then click Configure at the bottom of the
tab.