Allied Telesis AT-S63 - Manual (Page 202)

Chapter 17: SNMPv3
202 Section III: SNMPv3
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to first enable SNMP access
on the switch. Then you configure the SNMPv3 tables. See the following
procedures:
 “Enabling or Disabling SNMP Management” on page 203
 “Configuring the SNMPv3 User Table” on page 206
 “Configuring the SNMPv3 View Table” on page 214
 “Configuring the SNMPv3 Access Table” on page 220
 “Configuring the SNMPv3 SecurityToGroup Table” on page 227
 “Configuring the SNMPv3 Notify Table” on page 233
 “Configuring the SNMPv3 Target Address Table” on page 238
 “Configuring the SNMPv3 Target Parameters Table” on page 245
 “Configuring the SNMPv3 Community Table” on page 252
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesis does not recommend this configuration.