Allied Telesis AT-S63 - Manual (Page 321)

AT-S63 Management Software Web Browser User’s Guide
Secton V: Virtual LANs 321
Modifying a VLAN
This procedure explains how to add or remove ports from a tagged or
untagged VLAN. When modifying a VLAN, note the following:
 You cannot change the VID of a VLAN.
 You cannot change the name of a VLAN using the web browser
interface, but you can from the menus or command line interface.
 You cannot modify VLANs when the switch is operating in one of the
multiple VLAN modes.
 You cannot modify a protected posts VLAN or a MAC address-based
VLAN from the web browser interface.
 If the switch is using 802.1x Port-based Network Access Control and
you want to move an untagged port to a different VLAN, the port’s
802.1x role must be set to none. You cannot move an untagged port to
a different VLAN while the port is functioning as an 802.1x
authenticator or supplicant port. For instructions on how to change a
port’s 802.1x role, refer to “Setting Port Roles” on page 354.
To modify a VLAN, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 128 on page 316.
4. Click the button next to the name of the VLAN to be modified.
5. Click Modify.
The Modify VLAN page for the VLAN is displayed.
6. To add or remove ports from the VLAN, click on the appropriate ports
in the switch image. Clicking repeatedly on a port toggles the port
through the following possible settings:
7. Click Apply.
Untagged port
Tagged port
Port is not a member of the VLAN