Allied Telesis AT-S63 - Manual (Page 206)

Chapter 17: SNMPv3
206 Section III: SNMPv3
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
 “Creating a User Table Entry” on page 206
 “Deleting a User Table Entry” on page 209
 “Modifying a User Table Entry” on page 210
For reference information about the SNMPv3 User Table, see Chapter 21,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 75 on page 204.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure at the bottom of the tab.