Allied Telesis AT-S63 - Manual (Page 258)

Chapter 17: SNMPv3
258 Section III: SNMPv3
Displaying SNMPv3 Tables
This section contains procedures to display the SNMPv3 Tables. The
following procedures are provided:
 “Displaying User Table Entries,” next
 “Displaying View Table Entries” on page 260
 “Displaying Access Table Entries” on page 261
 “Displaying SecurityToGroup Table Entries” on page 262
 “Displaying Notify Table Entries” on page 263
 “Displaying Target Address Table Entries” on page 264
 “Displaying Target Parameters Table Entries” on page 265
 “Displaying SNMPv3 Community Table Entries” on page 266
Displaying User
Table Entries
To display entries in the SNMPv3 User Table, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Monitoring menu, select Mgmt. Protocols.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab displayed by default, as shown in Figure 13 on page
61.
3. Select the SNMP tab.