Metrohm tiBase 1.1 - Manual (Page 182)

4.4 Templates
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
174 ￭￭￭￭￭￭￭￭
tiBase 1.1
Multiple curves of the same command
Setting, which curves are displayed when the command has been run sev-
eral times, e.g. because of a LOOP command or a multiple call of a
Track.
Selection Show only last curve | Show all curves
Default value Show only last curve
Show only last curve
Only the curve generated during the last run of the command is dis-
played.
Show all curves
The curves of all runs of the command are displayed.
4.4.2.2.5 Curve overlay - Comment
Dialog window: Database ▶ Tools ▶ Templates ▶ Curve overlay tem-
plates... ▶ Curve overlay templates ▶ [Properties] ▶ Properties - Overlay curves -
'Name'
Entry of comment on the curve overlay template.
Comment
Comment on control chart.
Entry 1000 characters
4.4.3 Templates for control chart
4.4.3.1 Managing control chart templates
Menu item: Database ▶ Tools ▶ Templates ▶ Control chart templates... ▶ Control
chart templates
With the menu item Tools ▶ Templates ▶ Control chart templates...,
the dialog window Control chart templates opens in which the globally
available templates for control charts can be managed.
Template table
The table with the defined templates cannot be edited, although it can be
sorted according to the selected column in increasing or decreasing
sequence by clicking on the column title
Template name
Shows the name of the template.
Comment
Shows the comments about the template.