Metrohm tiBase 1.1 - Manual (Page 33)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiBase 1.1
￭￭￭￭￭￭￭￭ 25
Variable
name
(PC-Control)
Variable
name
( tiBase 1.1)
Description Command
.MEN .ENP Electrode zero point for the sen-
sor used for the command
(dimensionless for pH sensor or
in mV for the ISE sensor, num-
ber) and/or electrode zero point
calculated from the calibration
(for STDADD and CAL LOOP) DET pH, DET U, MET pH,
MET U, SET pH, SET U,
STAT, MEAS pH, MEAS U,
MEAS T, MEAS Conc, CAL
LOOP, DOS, STDADD
.EP{x}.DME Measured value differential for
the endpoint x (1…9) MET
.EF# .EP{x}.ERC ERC for the endpoint x (1…9) DET
.EM# .EP{x}.MEA Measured value for the endpoint
x (1…9) in the unit of the meas-
ured value DET, MET, SET, KFT, KFC
.ESI# .EP{x}.MEP Marking for the endpoint x
(1...9); 1 = 1 endpoint, 2 = 2 or
more endpoints DET, MET, SET, KFT
.EP# .EP.QTY Measured value (water) for the
endpoint in mg KFC
.ET# .EP{x}.TEM Temperature for the endpoint x
(1...9) in °C DET, MET, SET, KFT
.ED# .EP{x}.TIM Time for the endpoint x (1...9) in
s DET, MET, SET, KFT, KFC
.EP# .EP{x}.VOL Volume for the endpoint x (1…
9) in mL DET, MET, SET, KFT
.MCT .ETE End temperature (temperature
following processing of the com-
mand) in °C DET, MET, SET, KFT, KFC,
STAT, MEAS (without T/
Flow), CAL MEAS,
STDADD, DOS
.MCV .EVT End volume (total dosed volume
at the end of the command) in
mL DET, MET, SET, KFT, STAT,
DOS
.FM# .FP{x}.MEA Measured value for the fixed
endpoint x (1…9) in the unit of
the measured value DET, MET, SET, KFT, STAT
.FP{x}.QTY Measured value (water) for the
fixed endpoint x (1...9) in mg KFC
.FT# .FP{x}.TEM Temperature for the fixed end-
point x (1…9) in °C DET, MET, SET, KFT, STAT,
MEAS (without T/Flow)