Metrohm tiBase 1.1 - Manual (Page 240)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
232 ￭￭￭￭￭￭￭￭
tiBase 1.1
Results with statistics
Result name
Selection of the statistically evaluated result by using the result name for
which the single results of all determinations are shown.
Selection Result name
Table of single results
For the result selected above the following data for the individual determi-
nations is shown:
Determination start
Shows the date and time at which the determination was started.
Version
Shows the version number of the determination.
Sample size
Shows the sample size.
Result value
Shows the result value. The statistics data (mean value, standard devia-
tions, etc.) for the selected determination are listed in the subwindow
Result view .
[Determination on/off]
All single results of the selected determination for statistical calculations
can be switched off or on. If the determination is switched off then an
asterisk (*) appears behind all result values in the table and the line is
shown as inactive (gray); if it is switched on again then the asterisks will
disappear. However, updating the statistics data always only takes place
with [Recalculate].
[Result on/off]
Switch the selected single result for the statistical calculations off or on. If
the result is switched off, an asterisk (*) appears behind the result value, is
it switched on again, the asterisk disappears. However, updating the sta-
tistics data always only takes place with [Recalculate].