Metrohm tiBase 1.1 - Manual (Page 316)

5.2 Determinations
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
308 ￭￭￭￭￭￭￭￭
tiBase 1.1
5 If all results of the selected determination are to be switched on or
off for the statistics, click on [Determination on/off].
If the determination is switched off, then an asterisk (*) appears after
all result values in the table and the line is shown as inactive (gray); if
it is switched on again then the asterisks will disappear.
Note
If the results of a determination are switched off, the statistics for
these results will be switched off when this determination is recal-
culated, i.e. no data for the mean value and standard deviations
will be shown. However, the determinations remain statistically
linked to each other so that the results can also be switched on
again.
6 Click on [Recalculate].
The selected determinations are recalculated. The results of this recal-
culation are entered automatically in the Result view subwindow.
7 In the Reprocessing dialog window, click on [OK].
Each determination that has been modified by reprocessing will be
saved as a new version with a version number increased by +1 and
the Reprocessing dialog window will be closed. This button is disa-
bled for as long as recalculating has not yet been triggered and if not
all of the selected determinations could have been recalculated.
Editing curve evaluations
Note
The Curve evaluation tab is only shown when a single determination
is selected that contains curves that can be evaluated.
1 Change to the Curve evaluation tab.
2 In the Command name field, select the command whose curve is to
be displayed.
3 Click on [Edit].