Metrohm tiBase 1.1 - Manual (Page 284)

4.7 Results subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
276 ￭￭￭￭￭￭￭￭
tiBase 1.1
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
RTE RTE, °C, 1
Table 30 Command STDADD
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
SLO SLO, mV, 1
ENP ENP, mV, 1
RES RES, "selected
unit", 1
VAR VAR, "empty", 3
Table 31 Command DOS pH
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
MR MR.MRT, mL/min,
4 MR.MRS, mL/min,
4 MR.MRC, "empty",
3
Table 32 Command DOS U
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
MR MR.MRT, mL/min,
4 MR.MRS, mL/min,
4 MR.MRC, "empty",
3
4.7.4 Results - Calculation #
Tab: Database ▶ Results ▶ Command name
For each calculation command the results and (if existent and desired) the
corresponding statistical evaluations are displayed on a separate tab Cal-
culation_#. The sequence of the shown results corresponds to that
defined in the calculation command. The display of the statistical evalua-
tions can be selected in the dialog window Properties result window
For every single result a maximum of the following information is dis-
played:
Result "Result name"
Result "Result name"
Display of the result with variable name.