Metrohm tiBase 1.1 - Manual (Page 287)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiBase 1.1
￭￭￭￭￭￭￭￭ 279
Formula
on | off (Default value: on)
Shows the calculation formula.
Variables
on | off (Default value: off)
Displays the variables used in the formula.
4.8 Curves subwindow
4.8.1 Curves - General
Subwindow: Database ▶ Curves
Curves subwindow
The Curves 1 - 5 subwindows are subwindows in the Database pro-
gram part. In these subwindows, the measuring points generated by the
measuring commands for the focused determination in the Determina-
tion table are shown as a graph. When navigating in the determination
overview, this data will be updated automatically (after a certain time
delay).
The Curves 1 - 5 subwindows can be switched on in the Database pro-
gram part and thus made visible when the layout is defined. They can be
enlarged and reduced as required, and they can also be maximized.
Tabs
In the curve window a tab with the corresponding command name and
the run index (e.g. Chloride.1) is provided for each run of a measuring
command; their sequence is determined by the method.
Display of curves
The curves of the selected determination are shown on the tabs with the
properties defined per window and per command type. The command
type (e.g. DET pH) is shown above the left-hand y axis.
Curves can be zoomed as often as required by spanning a section of the
curve display with the left mouse button pressed down. Zooming can be
undone by double-clicking on the section of the graph or with the con-
text-sensitive Show All menu command.