Metrohm NIRS XDS MasterLab Analyzer User Manual
Page 24
22
▪▪▪▪▪▪▪
1
Load Vision Spectral Analysis Software onto
the computer designated to operate the XDS
instrument.
2
Place the monochromator on the lab bench in
the position shown.
3
Open the right-hand panel of the instrument.
Pull it gently by a fin, until the catch releases.
This panel opens to about a 45-degree angle
for access to connectors, and for filter
inspection. Avoid scratches or damage.
4
Gently thread the AC power cable and
network cable through the lower right corner
of the instrument access area as shown.
The cables should snap into the black holder.
The innermost position is large, to fit the
power cord. If the power cord is in the wrong
location, the door may not close fully.
The network cable may go into either of the
other two locations.