Metrohm NIRS XDS MasterLab Analyzer - Manual (Page 49)

▪▪▪▪▪▪▪ 47
6
Vision Software: Connection to the Instrument
This section describes communication between the computer (with Vision Software loaded) and the
XDS instrument. Please follow these steps to establish communication. The instrument may be “direct
connected” as explained in section 3.0 of this manual. Alternatively, the instrument and computer
must both be plugged into a live RJ-45 communication jack, on an active network.
IMPORTANT INSTALLATION NOTE:
For Vision to be installed correctly, the installer must
have “write access” to the directory containing the
Windows operating system. This directory may be
named “WINDOWS” (as shown) or “WINNT”.
For more information about permission for this file, see
section 3.0 of this manual.
For Vision to be installed correctly, the installer must have “write access” to the directory containing
the Windows operating system. This directory may be named
6.1 Entry into Vision
Install Vision on the computer to be used for
instrument operations.
Once installed, click on the Vision icon on the
desktop. The log-in box appears on the
opening screen.
Enter the default User ID, “NIRS”. It is not case-
sensitive.
Tab (or mouse) to the Password box, and enter
the default password, “NIRS”.
Note that you should set up specific User ID
and passwords for each authorized user. Do
not operate on the default User ID, or you will
be in violation of CFR 21, Part 11.