Audio tab for the speakerlinx sl250 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 143
Editing Devices
5-73
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
4.
After adjusting information on the Audio page, select Apply.
5.
If you have an Audio Port connected to this SpeakerLinX, select the Audio Port tab. If you don’t have an
Audio Port connected, skip to step 7.
Audio Port information displays (see Figure 5-58).
Figure 5-60
Audio Port tab
The Audio Port tab allows the SpeakerLinX to play music from any device connected through an Audio Port
in the room. Table 5-48 provides information on the fields available for editing the Audio Port tab.
Table 5-47
Audio Tab for the SpeakerLinX SL250
Tab
Selection Description
Audio
Room Name
The name of the room where the SpeakerLinX is located.
Speaker Impedance
Allows dealer to change the impedance settings of the
amplifier in the SpeakerLinX (default is 8 Ohms).
Service Type
A display field used to denote the service type.
Lineout Volume Level
Allows dealer to determine if the EIM line out will be fixed
(user cannot adjust volume from the TouchLinX) or variable
(volume can be adjusted from the ControLinX).
Stereo Mode
Choose between stereo, mono/summed, and bridged.
Micro Firmware
Lets you download the latest firmware for the device.
Audio Defaults
Lets you adjust Balance, Volume Level, and Volume Limit.
Default Graphic Equalizer
Lets you adjust the equalizer range for the SpeakerLinX.
Show Graphic EQ on user
interface
Enables the equalizer settings to be adjustable from the
TouchLinX.
Service Name
A display field used to identify the stream name.