After adjusting information, select apply, Controlinx ir/rs232 settings tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 162
DigiLinX Dealer Setup Version 2.35.00
5-92
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 5-78
Settings for the ControLinX IR/RS232 tab
The IR/RS232 Settings tab allows you to configure the communications settings used to interface with the
external system. These settings are dependent on the external system. Consult the external systems manual
for the appropriate settings.
Table 5-62 provides information on the fields on the IR/RS232 Settings tab.
5.
After adjusting information, select Apply.
6.
Select the Labels tab.
The Labels tab for the ControLinX hosting an Aprilaire displays in the right side of the window (see Figure 5-
74).
Table 5-62
ControLinX IR/RS232 Settings tab
Tab
Selection Description
IR/RS232 Settings
Service Name
A display field used to identify the stream name.
Driver
The driver used for the connected device.
Driver File
Designates which Lua File is loaded onto the ControLinX.
This will not change unless a custom driver file is being used.
Control Type
Defined by the specific product driver.
Enable Service
Enables or disables functionality.
Baud Rate
Information provided by the manufacturer of the attached
device.
Data Bits
Information provided by the manufacturer of the attached
device.
Parity
Information provided by the manufacturer of the attached
device.
Stop Bits
Information provided by the manufacturer of the attached
device.