Controlinx info tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 175
Editing Devices
5-105
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
The Info tab contains all of the information for the designated ControLinX. There is a field for the installer to
enter additional information about the device or host system. Table 5-73 provides information on the fields on
the Info tab.
3.
After adjusting information on the Info page, select Apply.
4.
Select the IR/RS232 Settings tab.
The IR/RS232 Settings tab for the ControLinX hosting Panorama displays in the right side of the window
(see Figure 5-90).
Table 5-73
ControLinX Info Tab
Tab
Selection Description
Info
Current IP Address
The current IP address of the ControLinX.
Current Subnet Mask
The current subnet mask of the ControLinX.
Device Type
The type of DigiLinX device that this is.
Model Number
The NetStreams ControLinX model number.
Firmware Version
The firmware version the device is running.
Device Name
Descriptive name the installer assigned to the device when
creating the project.
Override
Changes the default device name. Keep unchecked in most
instances.
Serial Number
Serial number of the ControLinX.
Device Comments
Indicate where the device is installed so that if you need to
return to the installation for service or upgrading devices, you
can have access to this information in the project file.
Port Name
Denotes the category of the driver being used for this
hardware.
Driver
Specifies the type of driver the CL100 was configured to use.
Control Type
Denotes whether the device is Serial or IR.
Show Advanced Options
Normally used for advanced configurations. Typically, the
installer will not use this screen.