Configuring the digilinx system, Configuring the digilinx system -2 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 246
DigiLinX Dealer Setup Version 2.35.00
9-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
address to the device that is not in the range of the home network or DigiLinX. Use
addresses from 192.168.0.2 through 192.168.0.50 and set the subnet mask to
255.255.255.0.
NOTE:
If the media server requires access to the Internet, you may need to set the
Gateway and DNS address on the physical digital media server. You can
retrieve this information from a home PC.
From a PC, select Start>Run. A run popup window displays. Type CMD in
the Open field. A DOS window displays. Type IPCONFIG/ALL at the DOS
prompt. This will display the IP address of the gateway and DNS for the home
network.
Set the IP address of the device according to the manufacturer’s instructions.
Configuring the DigiLinX System
DigiLinX is designed to run out-of-the-box on its own dedicated IP network. When
working with the home network is desired, the installer must customize the DigiLinX
IP addressing scheme. To set DigiLinX IP addresses in a compatible range with the
home network, follow these steps:
1.
Open Dealer Setup and create a new project or open an existing project. Do not
start the Wizard.
2.
Click on System - A/V Distribution in the left window pane.
3.
In the bottom right corner, click on the Show Advanced Option button as shown
in Figure 9-1.