Updating devices, Updating devices -2 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 38
DigiLinX Dealer Setup Version 2.35.00
3-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 3-1
Update StreamNet Devices\
NOTE:
If you hold the left mouse button down over the title bar of this window, you
can move the Wizard area to anywhere on your DigiLinX screen.
Updating Devices
To update firmware to the devices, complete the following steps:
1.
Select the latest Firmware Version from the dropdown list in the Firmware Version
field.
2.
Select individual devices or use the Select All button to select all devices to be
updated.
Devices to be updated are highlighted in green.
Tip: You may not want to
check “Include XM Station Art”
every time you update
devices. This feature updates
metadata for sources attached
to a MediaLinX and may take
quite a bit of time to load. To
skip the update of XM Station
Art, uncheck the box next to
“Include XM Station Art.”
3.
Select Update Devices from the lower right-hand corner of the window.
The devices run through several phases of updating. Each device is restarted. This
can take quite some time for larger systems. For especially large systems, devices
are updated ten at a time. It is normal for devices to restart more than once.
When all devices have been upgraded, you will see “Done” in the status column for
each device (see Figure 3-2).