ClearOne NetStreams DigiLinX Dealer - Manual (Page 52)

DigiLinX Dealer Setup Version 2.35.00
3-16
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
ˆ Model Number - selects the model number of this TheaterLinX.
ˆ AVR Driver - selects the driver that the TheaterLinX willl use to control the
receiver.
NOTE: AVR Driver needs to be set before making any other changes
ˆ Digi/AVR input: selects the source input on the receiver that the TheaterLinX is
using. Select from Sources 1 to 8.
2. Next, set the source options available under Available Sources. This section allows
you to define specific settings for each of the sources in the home theater. Using the
source identifier (the actual name depends on shich AVR driver you are using) set
the options that are appropriate for that source. For example, a tuner is connected to
Source 1 on the receiver, so in the Source 1 section set the appropriate options.
ˆ Source # - provides a name that can be used on the DigiLinX GUI. If you
specify one of the drivers, source # is replaced by the name of the source for
that driver.
ˆ Port - selects which IR port on the TheaterLinX is being used to control that
source.
ˆ Type - selects the source type (for example, if it is a tuner, select the tuner
driver).
ˆ Enable - used to prevent the TH100 from displaying unused source inuts on the
receiver.
Repeat this information for each source and then click Save & Continue.
NOTE: This is a good time to save your project. To make additional changes, select the
newly added TheaterLinX and select the Settings tab. Most of the settings are
carried over from when TheaterLinX was added.
3. The Add IP Speaker screen appears as shown in Figure 3-18.
Figure 3-18 IP speaker dialog box
Entering IP Speaker Information