3 setup procedure, Setup procedure – Toshiba SX 2000 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Chapt.1 System Configuration
1.3.3
Setup procedure
The following chart shows the setup procedure of the computer link mode.
Connect the S2T to the master computer by RS-485
or RS-232C interface. Refer to section 1.3.4 or 1.3.5
Select the computer link mode by setting the SW
resister, Refer to section 1.3.6
Set the station number, baudrate, parity, data bit
length, and stop bit. Refer to section 1.3.7
Once writing into the EEPROM, the setting is
effective until change mode.
Refer to section 1.3.8 and the separate “T-series
Computer Link manual” for the computer link protocol
20
Sequence Controller S2T
Advertising