6 communication parameter setting, Communication parameter setting, Nctfeiii – Toshiba SX 2000 User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.4 Free ASCII mode
1.4.6
Communication parameter setting
The communication parameter is set by writing it into the system information memory
of the S2T.
Turn the S2T to HALT mode, then set the communication parameter in the system
information.
(T-PDS screen example)
T-PDS32 for Windows - [UNTITLED] - Ma
-¡g|
File Edit View Search ^LO Debug Gamment Option WindodM jHelp
ilJ Stell g I a I
System Comments:
I-----------------------
Memory Capacity
64KS / 8KW
Steps Used
0
PLC Type
S2T
PLC Version
T-PDS Version
T-PDS32 for Windows V2.14
-PLC Date & Time
Date:
-Staf\:W6tie-
(*
^ncTfeiii
c
:Error Status
& Diag. Msg.^=
Diag. Msg.
Memory Size S Scan T'pr _________ | Retentive Memory Area...
Computer Link...
-laj
Comm Port:
Baud Rate:
96ÜQ
1 ^
Parity:
Cdd
Data Bits:
S
■"
r
Stop Bits:
■zi
O F F L I N E
|C:r.g.KZT.51 cancel I
J
Set baudrate, parity, data bit length, and stop bit.
Station number is ignored.
After the communication parameter setting, write it into the S2T’s built-in EEPROM
before turning off power.
6F8C0926
33