Table1-6-1 run contact operation – Toshiba SX 2000 User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapt.1 System Configuration
NOTE
*1 Which module controls the RUN contact ?
The only controller modules of station modules can control the RUN contact.
*2 RUN contact control
User can set the parameter to control the RUN contact operation in order to apply for variety
industrial system. The RUN contact isn’t operated even if the controller set to no-valid goes to
the HALT mode or the abnormal mode.
The parameter is set to be valid in the initial mode.
Table1-6-1 RUN contact operation
Type
RUN contact control
Setting
Remarks
valid
no-valid
Sequence controller
PU***T
O
—
Programmer
Computer
C2PU**
O
—
User program
Ethernet
EN6**
—
—
TC-net
CN6**
—
—
O
:The controller status is related to the RUN contact operation.
— :The controller status is not related to the RUN contact operation.
External 24Vdc Output Terminals
These terminals can be used to supply 24Vdc power to external devices such as
sensors or relay output modules.
56
Sequence Controller S2T