Toshiba SX 2000 - Manual (Page 63)

Chapt.1 System Configuration
F 0 F 8 7 0
RW100 HOI 23 D0220 “1” (H31) “0” (H30)
RW101 H4567 Converted D0221 “3” (H33) “2” (H32)
RW102 H89AB ^ D0222 “5” (H35) “4" (H34)
RW103 HCDEF D0223 “7” (H37) “6” (H36)
D0224 “9” (H39) “8” (H38)
D0225 “B” (H42) “A” (H41)
D0226 “D” (H44) “C” (H43)
D0227 “F” (H46) “E” (H45)
(3) ASCII to HEX conversion (ATOM)
FUN 66 ATOH ASCII to HEX conversion
Expression
Function
When the input is ON, the ASCII characters stored in n registers starting with A
is converted to the hexadecimal data and stored in В and after.
The lower byte of source A is stored as uppermost digit of destination 6, and
followed in this order.
The allowable ASCII character in the source table is "0" (H30) to "9" (H39) and
"A" (H41)to "F" (H46).
The allowable range of n is 1 to 64.
When index or constant value is set as source A., this function can be
performed under the condition that n is equal to 1. If n is more than 1, a
boundary error is occured.
Execution condition
Input Operation Output ERF
OFF No execution OFF
-
ON Normal execution ON -
Conversion data error (no execution) OFF ON
Operand
Device Register
Con­
start
Name
X Y S L R Z T. c. 1 0 X Y s L R w T c D F 1 0 1 J
к Index
W W w W W w w
/А Source V V V V V V V V V V V V V V V V
n Size 1 -64
в Destination V V V V V V V V V V V
46 Sequence Controller S2T