Futaba 3VCS - Manual (Page 14)

15
Before Using
Transmitter T3VCS
Nomenclature
Switch(SW1)
LCD screen Antenna
Pilot lamp
CH3 knob (KNOB)
Display switch
(DSP)
Carryng bar
Switch(SW2)
Digital trim 3
(DT3)
(See page 17 for the op-
erating instructions.)
Power
switch
Mechanical
ATL
adjusting
screw
Neutral
adjusting
(See page 23 for the operat-
ing instructions.)
(See page 18 for
the adjustment
instructions.)
(See page 19 for
the adjustment
instructions.)
Steering trim (DT1)
CAMPac
insertion
hole
Hook
(See page 17 for the operating
instructions.)
(See page 22 for the operating instructions.)
Edit buttons
Steering stick
Throttle stick
Throttle trim (DT2)
(See page 17 for the operating
instructions.)
*The switches, knobs, and trimmers in the figure are shown in the initial setting position.
Precautions when turning the power switch on and off.
When the data was changed using the edit keys or trim levers, wait at least two sec-
onds before turning off the power. If the power is turned off within two seconds after
the data was changed, the new data will not be written to memory.
Stick lever head the precautions
There is a small projection at the tip of the lever heads to prevent slipping. When
carrying the transmitter, be careful these projections do not damage your skin,
clothes, or other objects.