Futaba 3VCS - Manual (Page 52)

53
Functions
Start Function, Engine Cut/AT-START(Throttle system)
1 (Trottle position setup)
Set the throttle position by pressing the (+) or (-)
button.
2 (Preset position setup)
Select setup item "PRST" by pressing the (DN)
button and use the (+) and (-) buttons to set the
preset position of the throttlle servo.
"B100" ~ "B1" : Brake side
"0" : neutral
"F1" ~ "F100" : Forward side
Setting Example: (When amp used with an electric car)
Set the preset position to F75% at EPA100%.
3 ("READY" setting)
Select setup item "ATS" by pressing the (UP)
button twice, and press the (+) and (-) buttons
simultaneously for about 1 second. "READY"
blinks on the screen and the system enters the
READY state. Trottle stick operation starts the
function.
4 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
-If the throttle stick is moved to the set position while
‘READY’ is flashing, the throttle servo will move to
the set position. The throttle operation wait state is
reset when the throttle stick is returned.
-When using the Start function, always set the func-
tion by performing step 3 above each time.
Start function adjustment
(Preparation)
- Select function "AT&SW" at setup item "MODE".
- Select setup item "TH.P" and make the following ad-
justments.
READY setting
OFF
: off state
READY : Ready state
ACT
: on state
Setup items
ATS
: READY setting
TH.P : Throttle position
PRST : Preset position
MODE : Function selection
Setup item switching
- Use the (DN) or (UP) button to switch
the setup item.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.
Preset position
B100 ~ B1, 0, F1 ~ F100
Initial value: 0
Throttle position
5 ~ 95
Initial value: 5