Futaba 3VCS - Manual (Page 29)

30
Initial Set-Up
2. Modulation Mode Check
The T3VCS transmitter output signal format can be
changed to match the type of receiver. Check if the modu-
lation mode is set to match the receiver used.
When using an FM receiver (e.g., R133F), the modulation
mode must be set to "PPM". When using a PCM receiver
(e.g., R113iP), the modulation mode must be set to
"PCM". When using a H.R.S receiver (e.g., R203HF), the
modulation mode must be set to "HRS". If this setting is
incorrect, change it with the HRS/PCM/PPM Select (See
page 88) function.
"H.R.S"
4. Trims Initial Set-Up
- Steering trim (DT1) check
At initial set-up, steering trim (Trim 1) is assigned to digi-
tal trim DT1 below the stick at the right side of the trans-
mitter. Operate the DT1 lever and check if the steering
trim display on the screen changes. After checking the
trim, set the trim display to the center (N) position.
- Throttle trim (DT2) check
At initial set-up, throttle trim (Trim 2) is assigned to digi-
tal trim DT2 at the right side of the stick at the left side of
the transmitter. Operate the DT2 lever and check if the
throttle trim display on the screen changes. After checking
the trim, set the trim display to the center (N) position.
Throttle trim
(DT2)
Steering trim
(DT1)
Steering trim
Throttle trim
Set "BOAT" in case
of the ratchet type.
3. Throttle Mode check
The T3VCS transmitter will automatically stop its braking
function of the throttle operation when the throttle stick is
replaced with the ratchet type for boat or other purposes.
In this case, set "BOAT" for "TH-STK" in the Throttle
Mode (See page 100). In case of using a ratchet type stick
for a car, it is possible to set the servo travel at 5:5 or 7:3
upon your needs.