Futaba 3VCS - Manual (Page 71)

72
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
Servo Reverse/CH-REV(All channel)
This function reverses the direction of operation of the servos related to transmitter
steering, throttle, and channel 3 operation.
However, when the position set by trim or subtrim shifts from the center, the center
becomes the opposite side.
* Steering
* Throttle
* Channel 3
Sevo Reverse Function Setting
(Preparation)
- Preselect setup channel "ST", "TH", or "CH3".
1 (Servo reverse setting)
Use the (+) or (-) button to reverse the servo op-
eration direction.
(Each channel can be set similarly.)
2 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
* Normal side
* Reverse side
Servo Reverse/CH-REV(All channel)